2006 Arctic Cat ATVs factory service and repair manual, Page 449Get this manual

2006 Arctic Cat ATVs factory service and repair manual, Page 449

7Using side-cutters (or suitable substitute), remove both outside boot clamps from the shaftNote the position of the different-sized
must be replaced as an assembly1 NOTE: l NOTE: Grease Pack (pln 0441-173) contains 120 grams of greaseThe inside joint (double-offset)
requires approximately 70-90 grams of grease and the outside (bell-type) requires approximately 35-55 gramsWhen replacing
boots, use of the pack for inside boots and 113 of the pack for outside boots 6Using side-cutters (or suitable substitute),
remove the small clamp from the shaft A CAUTION Do no over-fill the joint as boot damage may occur resulting in joint failure
9Slide the new outside boot onto the shaft with the new clamps positioned as shownNote the different-sized clamps from removal1