2006 Arctic Cat ATVs factory service and repair manual, Page 452Get this manual

2006 Arctic Cat ATVs factory service and repair manual, Page 452

7Install the wheel and tighten to specifications8Remove the ATV from the support stand and release the brake lever lock 9Check
supported BEFORE removing the shock absorber IassembliesI - Rear Suspension 5Remove the four cap screws and nuts securing
the rear of the swing arm(s) to the axle housing REMOVING 1Place the ATV on support stand (positioned just in front of and
behind the footrest on each side) so the wheels are off the floor Make sure the ATV is solidly supported on the support stand