2006 Arctic Cat ATVs factory service and repair manual, Page 453Get this manual

2006 Arctic Cat ATVs factory service and repair manual, Page 453

6Maneuver the axle assembly rearward allowing the propeller shaft to disengage and the final drive boot to separate from
cap screws securing the hitch to the gear case; then remove the hitchCC763 2Remove the can screws securing the axle assembly
to the axle housing; then remove the axle assembly from the housingAccount for gasket 1 NOTE: Note that these cap screws
are 37 mm (1.5 in in length for installing purposes(cc764 5Remove the two cap screws securing each axle housing to the gear