2006 Arctic Cat ATVs factory service and repair manual, Page 454Get this manual

2006 Arctic Cat ATVs factory service and repair manual, Page 454

ASSEMBLING 1Grease the splines of the ring gear2Make sure the rear gear caseaxle housing O-ring is properly positioned; then
If new gear case is being installed, tighten the cap screws to 5.1-6.3 kg-m (37-45.5 ft-lb) 1Clean all external components
2Inspect the case for leaks or damage3Inspect splines for wear4Inspect the seal for damage 5Inspect housing mounting bosses
for wear or elongated holes6Inspect the frame welds for cracking or bending 7Inspect the rear drive and plug threads for
stripping or damage8Inspect the axle bearingsRotate the bearings by hand, and if any roughness or binding is noted, replace
the bearings 4Lightly grease the bearing housing seal; then slide the bearing housing onto the axle shaftSecure with the