2006 Arctic Cat ATVs factory service and repair manual, Page 456Get this manual

2006 Arctic Cat ATVs factory service and repair manual, Page 456

6Install the wheels and tighten to specifications 7Remove the ATV from the support stand1 NOTE: Check all fasteners for tightness
axles (see Drive Axles in this section)Remove the four cap screws securing the engine output shaft to the rear gear case
input flange 2Secure the engine output shaft to the rear gear case input flange with three cap screws (coated with red Loctite
#271) and lock nutsTighten to specifications3Install the rear drive axles (see Drive Axles in this section) 4Install the
left-side rear A-arms (see Rear A-Arms in Section 7) REMOVING 1Secure the ATV on sumort stand to elevate the wheel; then
remove thewheel 4Remove the two cap screws and lock nuts securing the rear gear case to the frame; then remove the gear casethrough