2006 Arctic Cat ATVs factory service and repair manual, Page 461Get this manual

2006 Arctic Cat ATVs factory service and repair manual, Page 461

Shock Absorbers REMOVING 1Secure the ATV on support stand to elevate the wheels and to release load on the suspension I rstand
additional support stands are necessary to support the rear axle when the shock absorbers are removed or damage mav occur
1Place the shock absorber spring over the shock absorber, compress the spring, and install the retainer 3Remove the two cap
screws and nut securing each rear shock absorber to the frame and rear suspensionAccount for bushings and sleeves from each
2Place bushings and sleeves (where appropriate) into shock eyelet; then install shock with two cap screws and nutsTighten
all nuts to specifications A CAUTION Do not tighten the nuts beyond the 4.8 kg-m (35 ft-lb) specification or the shock eyelet
or mount WILL be damaaed1 NOTE: On the fully independent rear suspension models, the rear shock absorber-to-lower A-arm torque