2006 Arctic Cat ATVs factory service and repair manual, Page 462Get this manual

2006 Arctic Cat ATVs factory service and repair manual, Page 462

Swing Arms (VP Rear Suspension) On the right side, place the outer swing arm into position and secure to the axle housing
avoid iniurv On the right side, remove the cap screw and lock nut securing the outer swing arm to the axle housing; then
remove the cap screw and lock nut securing the inner swing arm to the axle housingRemove the hose grommets from the hose
guidesRemove the swing arms and note the location of the hose guides on the inner swing arm (for installing purposes)CLEANING
AND INSPECTING 1 NOTE: Whenever part is worn excessively, cracked, or damaged in any way, replacement is necessary 2Remove
the cotter pin from the nutDiscard the cotter pin 1Clean all swing arm components in parts-cleaning solvent2Inspect all swing
arm weldments for cracks or unusual bends 3Remove the nut securing the hub4Remove the brake caliperAccount for two cap screws
and two 0.76 mm (0.030 in spacer washers 3Inspect all tubing for cracks or unusual bends INSTALLING 1On the right side, place