2006 Arctic Cat ATVs factory service and repair manual, Page 465Get this manual

2006 Arctic Cat ATVs factory service and repair manual, Page 465

8Apply grease to the hub and drive axle splines; then install the hub assembly onto the drive axle 13Install the wheel and
2Pump up the hand brake; then engage the brake lever lock3Remove the wheel 4Remove the cotter pin securing the hex nut; then
remove the hex nutRelease the brake lever lock5Remove the two brake calipers (right side only)1 NOTE: Do not allow the brake
calipers to hang from their cablethose 6Remove the cap screws and lock nut securing the shock absorber to the frame and lower
A-arm; then remove the shock absorber2 11Secure the hub nut (from step 9) to the shaftlaxleTighten to specifications12Install