2006 Arctic Cat ATVs factory service and repair manual, Page 467Get this manual

2006 Arctic Cat ATVs factory service and repair manual, Page 467

TIRE SIZE IUse only Arctic Cat approved tires when replacing 1 tiresuto socould result in unstable ATV do oneration The ATV
the ATV from the support standI TIRE INFLATION PRESSURE Front and rear tire inflation pressure should be 0.35 kgcm2 (5.0
psi)REMOVING 1Secure the ATV on support stand to elevate the wheels Wheels and Tires I rstand to avoid iniurvt Machine Screw
Brake Disc Wheel HubFront Hub Stud 5Cotter Pin 6Hex Nut 7Wheel $97 8Mounting Nut 9Tire Front 10Valve Stem 11Valve Stem Cap
12Wheel HubRear 13Wheel 14TireRear 1234 Make sure the ATV is solidly supported on the sup- 2Remove the wheels1 NOTE: Keep
left-side and right-side wheels separated for installing them on their proper sides CLEANING AND INSPECTING 1 NOTE: Whenever
part is worn excessively, cracked, or damaged in any way, replacement is necessary 1Clean the wheels and hubs with parts-cleaning
solvent2Clean the tires with soap and water 3Inspect each wheel for cracks, dents, or bends4Inspect each tire for cuts, wear,