2006 Arctic Cat ATVs factory service and repair manual, Page 474Get this manual

2006 Arctic Cat ATVs factory service and repair manual, Page 474

5Insert the tie rod ends into the knuckles; then install the slotted nuts and tighten to specificationsLock the nuts with
slotted nutsTighten to specifications; then install new cotter pins1 NOTE: If the slots do not align with the holes in the
tie rod ends, tighten the nuts just enough to allow installation of the cotter pins 7Install the gas tank (see Section 4)
8Install the inner splash shields (see FrontRear Body Panel in this section)1NOTE: Turn the gas tank valve to the ON position
only if starting the engine INSTALLING (5001650 H11650 V-Twin) 1Place the steering post into position; then secure the lower