2006 Arctic Cat ATVs factory service and repair manual, Page 475Get this manual

2006 Arctic Cat ATVs factory service and repair manual, Page 475

5Lower the ATV and place the handlebar and caps into position on the steering post; then position the speedometer on top
slides free of the handlebarINSPECTING 1 NOTE: Whenever part is worn excessively, cracked, or damaged in any way, replacement
is necessaryCD670 7Place the instrument pod into position over the speedometer; then secure with two reinstallable rivets
and the ignition switch locking ring 1Inspect the grip for wear, cuts, or cracks2Inspect the grip for deteriorationINSTALLING
1NOTE: Before installing grip, use contact spray or alcohol to clean the inside of the grip and the handlebar of glue residue,
oil, or any other contaminant[1Apply liberal amount of Handlebar Grip Adhesive (pln 0636-071) to the inside of the 2Align
the rivet hole in the grip with the rivet hole in the handlebar; then align the notch (inside the grip) with the slot in