2006 Arctic Cat ATVs factory service and repair manual, Page 476Get this manual

2006 Arctic Cat ATVs factory service and repair manual, Page 476

4Install the plug on the head of the rivet Steering Knuckles REMOVING AND DISASSEMBLING 1Secure the ATV on support stand
cracked, or damaged in any way, replacement is necessary 6Remove the cotter pin from the tie rod end and remove the tie rod
end from the knuckle 1Clean all knuckle components2Inspect the bearing for pits, gouges, rusting, or premature wear 7Remove
the two cap screws securing the ball joints in the knuckle8Tap the ball joint end out of the knuckle; then remove the knuckle9Remove
the seal from the knuckle 3Inspect the knuckle for cracks, breaks, or porosity 4Inspect threads for stripping or damageASSEMBLING
and INSTALLING 1Install the bearing 2Install the bearing retainer 10Remove the bearing retainer 3Install new seal into the