2006 Arctic Cat ATVs factory service and repair manual, Page 481Get this manual

2006 Arctic Cat ATVs factory service and repair manual, Page 481

4Remove the left-side and right-side fender splash panels; then remove one press-in fastener and one reinstallable rivet
spring 8Remove the two cap screws and lock nuts securing the left foot peg and remove the foot peg 9Remove eight cap screws
and lock nuts and one reinstallable rivet securing the right-side footwell to the fenders 10Lift and support the rear of
the body to allow access to the torx-head cap screws securing the front and rear body sections together; then remove six
self-locking nuts (three from each side)Remove the rear body panel; then remove the front one 7Remove the front and rear