2006 Arctic Cat ATVs factory service and repair manual, Page 486Get this manual

2006 Arctic Cat ATVs factory service and repair manual, Page 486

1 NOTE: It may be necessary to rotate the body panel to the right to align the opening with the handlebar 3Make sure the
plastic rivets on each side to secure the front fenders to the footwellsTighten the flange nuts securely1 NOTE: If the footwells
have been removed, see 1Rotate the handlebar to the full-left position; then place the front body panel over the handlebar
and rotate and lower into position Footrests in this section 5Install four cap screws securing the front body panel to the
frame and rear panel 2Connect the headlight connectors to the appropriate headlights and the front accessory plug wires to