2006 Arctic Cat ATVs factory service and repair manual, Page 490Get this manual

2006 Arctic Cat ATVs factory service and repair manual, Page 490

2Place the rear rack in position with four bushings and secure with four machine screws and flanged nutsTighten securely
cover CLEANING AND INSPECTING 1 NOTE: Whenever part is worn excessively, cracked, or damaged in any way, replacement is necessary
1Clean all rear body panel components with parts-cleaning solvent and soap and water 2Inspect side panels and rear body panel
for cracks and loose rivets3Inspect threaded areas of all mounting bosses for stripping 4Inspect for missing decalsINSTALLING
5Secure the front and rear uanels with two machine screws; then install the left and right side panels1NOTE: If the front
body panel has not been installed, see Front Body PanellSide Panels in this section 1Remove the gas tank cap and set the
rear body panel in position; then install the cap and connect the brakehaillight connector8-22 Page: 490 Arctic Cat ATV 2006