2006 Arctic Cat ATVs factory service and repair manual, Page 492Get this manual

2006 Arctic Cat ATVs factory service and repair manual, Page 492

3Remove the two cap screws and lock nuts securing the cargo box to the frame; then remove the cargo box and discard the lock
headlight aim 2Measure the distance from the floor to the mid-point of each headlight3Using the measurements obtained in
step 2, make horizontal marks on the aiming surface 1Clean all cargo box components with soap and water 2Inspect the cargo
box for cracks, tears, and loose mounting hardware3Inspect the welds of the cargo box frame for cracking or bending4Inspect
the cargo box gate latches for smooth operationINSTALLING 4Make vertical marks which intersect the horizontal marks on the
aiming surface directly in front of the headlights5Switch on the lightsMake sure the HIGH beam is onDO NOT USE LOW BEAM 1Place
the cargo box into position on the frameSecure with cap screws and new lock nutsTighten to specifications 6Observe each headlight
beam aimProper aim is when the most intense beam is centered on the vertical mark cm (2 in below the horizontal mark on the
aiming surface 7Adjust each headlight by turning the adjustment knob counterclockwise to lower the beam or clockwise to raise