2006 Arctic Cat ATVs factory service and repair manual, Page 502Get this manual

2006 Arctic Cat ATVs factory service and repair manual, Page 502

4Using two open-end wrenches, remove the lock nut securing the shift rod to the upper shift armRemove the shift rod and discard
and secure with the existing E-clip (TBXTRV400500650 HI)On the 650 V-Twin, connect the front and rear shift arms with two
cap screwsOnly finger-tighten at this time REPLACING SPEEDOMETER To replace the speedometer, use the following procedure1Remove
the two reinstallable rivets securing the instrument pod; then remove the ignition switch retaining ring2Remove the two nuts
securing the mounting studs; then remove the speedometer and discon nect the multi-pin connector3Mount the speedometer and
secure with the two nuts; then connect the multi-pin connector 2Using new lock nut (B), secure the shift rod to the upper