2006 Arctic Cat DVX 400 Service Manual, Page 22Get this manual

2006 Arctic Cat DVX 400 Service Manual, Page 22

NutsBoltsCap Screws Tighten all nuts, bolts, and cap screwsMake sure rivets holding components together are tightReplace
! WARNING Do not attempt to remove the bulb when it is hotSevere burns may result ! CAUTION Tighten the lens cover screws
only until they are snug To replace the headlight bulb, use the following procedure1Turn the bulb counterclockwise; then
remove from the reflector housing2Disconnect the two-wire connector from the bulb; then connect the new bulb to the connector3Install
the bulb into the reflector housing and turn the bulb clockwise to lockTAILLIGHT-BRAKELIGHT CHECKINGADJUSTING HEADLIGHT AIM
The headlights can be adjusted vertically and horizontallyThe geometric center of the HIGH beam light zone is to be used
for vertical and horizontal aiming1Position the ATV on level floor so the headlights are approximately 6.1 (20 ft) from an
aiming surface (wall or similar aiming surface)NOTE: There should be an average operating load on the ATV when adjusting
the headlight aim To replace the taillight-brakelight bulb, use the following procedure1Twist the socket counterclockwise