2006 Arctic Cat DVX 400 Service Manual, Page 25Get this manual

2006 Arctic Cat DVX 400 Service Manual, Page 25

DRepeat step until no air bubbles are observed in the bleeder lineClose the bleeder screw and tightenEPerform steps B,C,
tighten the cover; then depress the brake pedal several timesCRemove the protective cap, install one end of clear hose on
the REAR bleeder screw, and direct the other end into container; then while holding slight pressure on the brake pedal, open
the bleeder screw and watch for air bubblesClose the bleeder screw before releasing the brake pedalRepeat this procedure
until no air bubbles are presentDRepeat step until the brake pedal is firm7Carefully inspect the hydraulic brake hoses for
cracks or other damageIf found, the brake hoses must be replaced ! CAUTION This hydraulic brake system is designed to use
high-temperature DOT brake fluid onlyIf brake fluid must be added, care must be taken as brake fluid is very corrosive to
painted surfaces INSPECTING HOSES Carefully inspect the hydraulic brake hoses for cracks or other damageIf found, the brake
hoses must be replacedMEASURINGREPLACING FRONT BRAKE PADS 730-434B NOTE: During the bleeding procedure, watch the reservoir