2006 Arctic Cat DVX 400 Service Manual, Page 27Get this manual

2006 Arctic Cat DVX 400 Service Manual, Page 27

MEASURINGREPLACING REAR BRAKE PADS 5Using calipers, measure the thickness of each brake pad6If the thickness of any brake
if this occurs 2Bend down the locking tabs (A) on the washer and remove the brake pad mounting pins (B); then remove the
brake pads 8Carefully separate the brake pads to allow the assembly to slip over the rotor; then install and secure to the
rear housing with the two cap screwsTighten to specifications (see Section 10)NOTE: It may be necessary to loosen the parking
brake adjuster screws in order to open the pads sufficiently to clear the rotorAnytime the rear brake pads are replaced,
the parking brake MUST be adjusted ADJUSTING PARKING BRAKE To adjust the parking brake, use the following procedure1Loosen
the parking brake adjuster lock nut (1) while holding the adjuster (2) with screwdriver; then turn the adjuster counterclockwise