2006 Arctic Cat DVX 400 Service Manual, Page 31Get this manual

2006 Arctic Cat DVX 400 Service Manual, Page 31

9Install new driven sprocket; then apply red Loctite #271 to the sprocket mounting cap screws and tighten to specifications
then remove the drive chain5Remove the four cap screws securing the driven sprocket to the sprocket hub; then remove the
sprocket from the axle6Remove the two cap screws securing the drive sprocket cover; then remove the cover 13Install new cotter
pin; then install the wheel and tighten the lug nuts to specifications (see Section 10) using crisscross pattern 7Remove