2006 Arctic Cat DVX 400 Service Manual, Page 35Get this manual

2006 Arctic Cat DVX 400 Service Manual, Page 35

(RemovingDisassemblingAssembling Installing) Table of Contents 2Remove the negative cable from the battery; then remove the
then drain the engine coolant4Remove the lower engine protective cover (1); then drain the oil from the crankcase Removing
Engine Transmission Many service procedures can be performed without removing the enginetransmission from the frameClosely
observe the note introducing each sub-section for this important information 5Drain the oil from the oil tank6Remove the
gearshift lever (2) and account for the two spacers7Remove the engine oil outlet pipe (3) and the inlet pipe (4); then remove
the spacer and O-ring from behind the outlet pipe AT THIS POINT If the technician's objective is to servicereplace the starter
clutch, starter torque limiter, starter, or water pump, the enginetransmission does not have to be removed from the frame
Secure the ATV on support stand to elevate the wheels ! WARNING Make sure the ATV is solidly supported on the support stand