2006 Arctic Cat DVX 400 Service Manual, Page 60Get this manual

2006 Arctic Cat DVX 400 Service Manual, Page 60

6Install the new bearing using the bearing installer; then apply small amount of red Loctite #271 to the bearing retainer
rod away from the dial indicator3Maximum deflection must not exceed specificationsSP220 7Inspect all the oil seals for wear,
nicks, or lip damageIf any damage is found, replace the seal8Thoroughly clean all crankcase mating surfaces prior to assemblyCRANKSHAFT
ASSEMBLY Measuring Connecting Rod (Small End Inside Diameter) Measuring Connecting Rod (Big End Side-to-Side) 1Push the lower
end of the connecting rod to one side of the crankshaft journal2Using feeler gauge, measure the gap between the connecting