2006 Arctic Cat DVX 400 Service Manual, Page 67Get this manual

2006 Arctic Cat DVX 400 Service Manual, Page 67

NOTE: Rotate the shafts back and forth to ensure no binding or sticking occurs 5In crisscrosscase-to-case pattern, tighten
tighten only until snug APrimary Drive Gear BCrank Balancer Gear CCam Chain NOTE: It will be necessary to install the starter
driven gear, starter one-way clutch, and the rotorflywheel on the left side prior to installing right-side componentsThis
is done to provide means of holding shafts for tightening right-side shaft nuts 1Install the starter driven gear (1) and
the key (2); then clean any oil or grease from the tapered portion of the crankshaft and from inside the rotorflywheel tapered