2006 Arctic Cat DVX 400 Service Manual, Page 82Get this manual

2006 Arctic Cat DVX 400 Service Manual, Page 82

NOTE: Check float arm height (A) by placing the carburetor on its side wfloat contacting the needle; then measure with caliper
Prior to assembling, the carburetor components should be cleaned and inspected (see Cleaning and Inspecting Carburetor sub-section)
ASSEMBLING ! CAUTION It is important to press down on the primer housing until it contacts the carburetor to make sure the
diaphragm lip is properly seated in the groove in the carburetorIf the diaphragm is not properly seated, leakage will occur
1Screw the idle adjustment screw into the carburetor making sure the washer and spring are properly positioned2Install the
pilot jet (20)Tighten securely; then install the starter jet (19)3Install the main jet into the needle jet holder (17) and
tighten securely; then install the needle jet holder assembly into the carburetor and tighten securely 7Place the jet needle,
spring seat, and spring into the piston valve; then place the assembly down into the carburetor CC746 SP287B 4Place the float