2006 Arctic Cat DVX 400 Service Manual, Page 83Get this manual

2006 Arctic Cat DVX 400 Service Manual, Page 83

1Place all metallic components in wire basket and submerge in carburetor cleaner2Soak for 30 minutes; then rinse with fresh
the choke cable end onto the carburetor3Place the throttle cable into position and secure by tightening the outer jam nut4Connect
the throttle cable to the actuator arm5Place the throttle actuator cover into position on the carburetor making sure the
O-ring is properly positioned; then secure with three screws6Position the carburetor in the air cleaner and intake pipe boots;
then secure with the clamps7Connect the hose at the fuel valve connection 8Secure the air-intake snorkel9Install the seat
and make sure it locks in position 11Inspect the carburetor mounting flange for damage and tightness Throttle Cable Free-Play
1Check throttle cable free-play at the lever; free-play should be 3-5 mm (1815 in2To adjust, slide the rubber boot away from
the adjuster located near the throttle leverLoosen the jam nut and rotate the adjuster in the appropriate direction until