2006 Arctic Cat DVX 400 Service Manual, Page 87Get this manual

2006 Arctic Cat DVX 400 Service Manual, Page 87

ASSEMBLINGINSTALLING 1Place the rotors into the pump housing making sure the alignment pin is in the groove of the rotor2Install
adapter 4Remove the oil lines from the tankAccount for the two O-rings (7) and two alignment pins (8) NOTE: Some oil seepage
may occur when installing the oil pressure gaugeWipe up oil residue with cloth 3Start the engine and run at the specified
RPM4The oil pressure gauge must read 0.2 kg-cm (2.8 psi)0.6 kg-cm (8.5 psi)NOTE: If the oil pressure is lower than specified,
check for an oil leak, damaged oil seal, or defective oil pumpNOTE: If the oil pressure is higher than specified, check for
too heavy engine oil weight (see Section 2), clogged oil passage, clogged oil filter, or improper installation of the oil
filterATV2181A 5Remove the cap screws securing the tank to the frame; then remove the overflow hose and remove the tankAccount