2006 Arctic Cat DVX 400 Service Manual, Page 92Get this manual

2006 Arctic Cat DVX 400 Service Manual, Page 92

2Place the new shaft seal into the housing; then tap it down until it is fully seatedNOTE: large, deep socket can be used
4Connect the radiator hose; then fill the cooling system with the recommended amount of coolant AN604D SP307A INSTALLING
1Install new O-ring in the water pump case; then attach the case to the clutch cover NOTE: While the cooling system is being
filled, air pockets may develop; therefore, run the engine for five minutes after the initial fill, shut the engine off,
and then fill the cooling system 5Refill the engine oil tank; then run the engine for several minutes and check for leaksRecheck
the engine oil and coolant levels6Check the entire cooling system for leakage ! CAUTION After operating the ATV for the initial