2006 Arctic Cat DVX 400 Service Manual, Page 96Get this manual

2006 Arctic Cat DVX 400 Service Manual, Page 96

Testing Electrical Components All of the electrical tests should be made using the Fluke Model 73 Multimeter (pn 0644-191)
Brake) NOTE: For ease of access to the electrical connectors, removing the seat and body is recommended (see Section 8) 1Set
the meter selector to the OHMS position2Connect the red tester lead to the orange wire; then connect the black tester lead
to the blackwhite wire The switch connector is the two-prong one located in front of the steering postRESISTANCE (Switch
Connector) ! CAUTION Always disconnect the battery when performing resistance tests to avoid damaging the multimeterAR621D
1Set the meter selector to the OHMS position2Connect the red tester lead to the orange wire; then connect the black tester
lead to the blackwhite wire3When the brake lever is compressed, the meter must show less than ohmNOTE: If the meter shows
more than ohm of resistance, troubleshoot or replace the switchcomponent, the connector, or the switch wiring harness 3When
the pedal is depressed, the meter must show less than ohmNOTE: If the meter shows more than ohm of resistance, troubleshoot