2006 Arctic Cat DVX 400 Service Manual, Page 99Get this manual

2006 Arctic Cat DVX 400 Service Manual, Page 99

Primary Winding 1Connect the red tester lead to the terminal (with the wire removed); then connect the black tester lead
jumper ground wire to the bluewhite (temperature) wire on the indicator light connector3The water temperature indicator light
should illuminateAR603D 2The meter reading must be within specificationNOTE: If the meter does not show as specified, replace
the spark plug cap NEUTRAL INDICATOR LIGHT 1Connect the jumper positive wire to the power source terminal on the indicator
light connector2Connect the jumper ground wire to the blueblack (neutral) wire on the indicator light connector3The neutral
indicator light should illuminateREVERSE INDICATOR LIGHT Indicator Lights The indicator lights connector being tested is
the four-wire one in front of the steering post 1Connect the jumper positive wire to the power source terminal on the indicator
light connector2Connect the jumper ground wire to the bluered (reverse) wire on the indicator light connector3The reverse