2006 Arctic Cat DVX 400 Service Manual, Page 100Get this manual

2006 Arctic Cat DVX 400 Service Manual, Page 100

INDICATOR LIGHTS VOLTAGE NOTE: The ignition switch must be in the ON position, and the test must be performed on the lower
connector, or the switch wiring harness 1Set the meter selector to the DC Voltage position2Connect the red tester lead to
the orange wire; then connect the black tester lead to ground3The meter must show battery voltageNOTE: This is the only voltage
test for all indicator lights After testing procedures are completed, use the following procedure1Connect the indicator light
four-wire connector to the main harness2Install the body and seat (see Section 8) Ignition Switch The connector is the three-wire
one in front of the steering postTo access the connector, the body and seat must be removed (see Section 8) VOLTAGE NOTE:
Perform this test on the lower side of the connector Handlebar Control Switches The connector is the yellow one in front
of the steering postTo access the connector, the body and seat must be removed (see Section 8)NOTE: These tests should be