2006 Arctic Cat DVX 400 Service Manual, Page 105Get this manual

2006 Arctic Cat DVX 400 Service Manual, Page 105

11Inspect the armature for shorting using "growler" and the following procedureAPlace the armature in the "growler BWhile
O-Ring O-Ring Bolt Nut 0739-228 1Align the tab on the brush holder with the notch in the right-side cover; then install the
holder2On the positive post, install an O-ring washer, fiber washer, flat washer, and lock washerSecure with the nut3Install
the armature into the starter housing; then while holding the brushes out, slide the commutator into the brush holder4Apply
small amount of grease to the right-side cover bushing; then install the cover on the starter housing making sure the O-ring
is in place and the reference marks align5Install the washer set on the armature shaft; then install the housing O-ring on
the starter housing6Apply small amount of grease to the left-side cover bushing7Place the left-side cover onto the starter
housing making sure the housing O-ring is in place and it seats properly8Apply red Loctite #271 to the threads of the two