2006 Arctic Cat DVX 400 Service Manual, Page 106Get this manual

2006 Arctic Cat DVX 400 Service Manual, Page 106

10Secure the positive cable to the starter with the nut and tighten to specification (see Section 10)11Connect the battery
shows battery voltage, continue with step 6 1Set the meter selector to the DC Voltage position2Connect the red tester lead
to the starter terminal; then connect the black tester lead to ground3With the starter button depressed, the meter must show
battery voltage and the starter motor should operate 6Connect the red tester lead to the yellowblack wire on the starter
relay; then connect the black tester lead to ground7Compress the clutch lever; then depress the starter button8The meter
should show battery voltageNOTE: If the meter shows battery voltage, the starter relay is defectiveIf the meter does not
show battery voltage, troubleshoot the starter switch, emergency stop switch, clutch lever position, or the ignition switch
CDI Unit The CDI is located beneath the left rear fender near the voltage regulatorNOTE: The CDI unit is not serviceable
componentIf the unit is defective, it must be replaced NOTE: If the meter showed battery voltage but the starter did not