2006 Arctic Cat DVX 400 Service Manual, Page 108Get this manual

2006 Arctic Cat DVX 400 Service Manual, Page 108

VOLTAGE (Brakelight) NOTE: Perform this test on the main harness side of the connectorAlso, the ignition switch should be
wiring harness, connectors, and switchesIf the meter shows battery voltage, replace the bulb 1Disconnect the three-pin connector
on the TPS harness from the main wiring harness2Remove the two machine screws securing the TPS to the carburetor; then remove
the TPS Throttle Position Sensor INSTALLING RESISTANCE 1Set the meter selector to the OHMS position2Disconnect the three-pin
connector on the TPS harness; then connect the red tester lead to the yellow-wire pin and the black tester lead to the black-wire
pin 1Place the TPS into position on the carburetor; then secure with the two machine screws 2Connect the three-pin connector
on the TPS harness to the main wiring harnessNOTE: No adjustments can be made to the TPSSP441A 3With the throttle in the