2006 Arctic Cat DVX 400 Service Manual, Page 114Get this manual

2006 Arctic Cat DVX 400 Service Manual, Page 114

8Remove the axle housing from the swing armCLEANING AND INSPECTING 1Inspect the sprocket teeth for wearIf they are worn as
bearing must be directed outwardATV2186 3Inspect the dust seals for wear of damageIf any defect is found, replace the dust
seal4Inspect the axle bearings by rotating them by handIf any roughness, binding, or excessive loosness is found, replace
the axle bearingsNOTE: If the axle bearings are replaced, replace the dust seals with new onesAlways pack the bearings with
good quality wheel bearing grease 2Install the spacer; then install the left bearing (2) REMOVING BEARINGS 1Remove the dust
seal using an appropriate seal removal tool; then using an appropriate bar (1), drive the bearings out of the axle housingAccount