2006 Arctic Cat DVX 400 Service Manual, Page 115Get this manual

2006 Arctic Cat DVX 400 Service Manual, Page 115

3Install new dust seals and lightly coat with greaseINSTALLING 1Install the axle housing in the swing arm; then install and
red Loctite #271 to the threads on the axle and using the torque wrench adapter, tighten the inner axle nut to the calculated
specificationNOTE: It is necessary to calculate the torque value using the following formula due to the offset of the special
tool used to tighten the axle nuts ATV2188 4Apply Three Bond Sealant (pn 0636-070) to the left and right ends of the sprocket
hub; then install the hub on the axleNOTE: If the sprocket was removed, see Section for sprocket installation procedure T: