2006 Arctic Cat DVX 400 Service Manual, Page 133Get this manual

2006 Arctic Cat DVX 400 Service Manual, Page 133

CLEANING AND INSPECTING Wheels and Tires TIRE SIZE NOTE: Whenever part is worn excessively, cracked, or damaged in any way,
cause poor handling qualities of the ATV and could cause excessive drive train damage not covered by warranty 1Install each
wheel on its hub TIRE INFLATION PRESSURE Tire inflation pressure should be 0.30 kgcm (4.4 psi) front and 0.275 kgcm (4.0
psi) rearREMOVING 1Secure the ATV on support stand to elevate the wheels ! WARNING Make sure the ATV is solidly supported
on the support stand to avoid injury NOTE: Make sure each wheel is installed on its proper hub as noted in removing (the
"rotation arrow" must indicate forward direction of rotation) 2Remove the wheelsNOTE: Keep left-side and right-side wheels
separated for installing them on their proper sides 2Tighten to specifications (see Section 10)CHECKINGINFLATING 1Using an