2006 Arctic Cat DVX 400 Service Manual, Page 147Get this manual

2006 Arctic Cat DVX 400 Service Manual, Page 147

4Inspect the brake hose for cracks and deterioration and the condition of the fittings (threaded and compression)5Inspect
then install the rubber boot3Align the master cylinder mount (A) to the punch mark (B) on the handlebar (E); then install
the clamp bolts (D) 6Fill the master cylinder with DOT brake fluid; then bleed the systemSee Section 2 Rear Brake PedalMaster
Cylinder Assembly REMOVING 1Connect clear plastic hose to the bleeder screw on the rear brake caliper; then loosen the bleeder
screw and pump the foot brake until the fliud is pumped into suitable container2Disconnect the brake hose (2) by removing
the union bolt (1)Loosen the jam nut (3); then remove the mounting cap screws (4), turn the push rod (5) out of the connector,