2006 Arctic Cat DVX Utility 250 Service Manual, Page 17Get this manual

2006 Arctic Cat DVX Utility 250 Service Manual, Page 17

1Place the ATV on level ground2Loosen the fill plug; then remove the transmission drain plug and drain the transmission lubricant
the fill plug 3Install the drain plug and tighten securely4Remove the fill plug and pour the appropriate amount of recommended
lubricant into the fill hole5Install the fill plug and tighten securely6Check the area around the drain plug for leakage
! CAUTION Water entering the outer end of the axle will not be able to enter the rear drive unless the seals are damaged
Drive Chain (DVX Model) Transmission Lubricant Change the lubricant according to the Periodic Maintenance ChartWhen changing
the lubricant, use approved SAE 80W-90 hypoid gear lubeTo change the lubricant, use the following procedure Drive chain condition
and adjustment should be inspected each day before the ATV is operatedAlways follow the following guidelines for inspecting