2006 Arctic Cat DVX Utility 250 Service Manual, Page 20Get this manual

2006 Arctic Cat DVX Utility 250 Service Manual, Page 20

Ignition Timing The ignition timing cannot be adjusted; however, verifying ignition timing can aid in troubleshooting other
unit may be faulty 3Install the new bulb into the headlight housing; then secure with the spring clip4Connect the three-wire
connector to the bulb; then install the bootTAILLIGHT-BRAKELIGHT HeadlightTaillightBrakelight Each time the ATV is used,
lights should be checked for proper functionTurn the ignition switch to the LIGHTS position; the headlights and taillight
should illuminateTest the brakelight by compressing the brake leverThe brakelight should illuminateHEADLIGHT NOTE: The bulb
portion of the headlight is fragileHANDLE WITH CAREWhen replacing the headlight bulb, do not touch the glass portion of the
bulbIf the glass is touched, it must be cleaned with dry cloth before installingSkin oil residue on the bulb will shorten
the life of the bulb To replace the taillight-brakelight bulb, use the following procedure1Remove the two screws and remove
the lens cover2Push the bulb in and turn it counterclockwise3Install the new bulb by turning it clockwise while pushing in4Install