2006 Arctic Cat DVX Utility 250 Service Manual, Page 22Get this manual

2006 Arctic Cat DVX Utility 250 Service Manual, Page 22

Electrical Connections The electrical connections should be checked periodically for proper functionIn case of an electrical
following procedure1With the master cylinder in level position, check the fluid level in the reservoirIf the level in the
reservoir is not visible in the sight glass, add DOT brake fluidKM116A NOTE: During the bleeding procedure, watch the reservoir
sight glass very closely to make sure there is always sufficient amount of brake fluidFailure to maintain sufficient amount
of fluid in the reservoir will result in air in the system DAt this point, perform steps and on the other FRONT bleed screw;
then move to the REAR bleed screw and follow the same procedureKM113 4Carefully check the entire hydraulic brake system that
all hose connections are tight, the bleed screws are tight, the protective caps are installed, and no leakage is present
! CAUTION This hydraulic brake system is designed to use DOT brake fluid onlyIf brake fluid must be added, care must be taken