2006 Arctic Cat DVX Utility 250 Service Manual, Page 25Get this manual

2006 Arctic Cat DVX Utility 250 Service Manual, Page 25

NOTE: Whenever installing new pads, the new pads must be burnished (see Burnishing Brake Pads in this section) 2Remove the
of any brake pad is less than 1.0 mm (0.039 in, the brake pad must be replacedNOTE: The brake pads should be replaced as
set 5Using calipers, measure the thickness of the discIf any portion of the disc is less than 3.00 mm (0.12 in, the brake
pads must be replaced (see Section 6)Installing 1Install the brake pads in the caliper; then insert the brake spring plateKM246A
1Remove the brake pad dust cover; then remove the clip pin and pull the brake pad retaining pin out of the caliper 2Install
the brake pad retaining pin and secure with the clip pin; then install the dust coverKM242 KM244 KM244 3Burnish the brake