2006 Arctic Cat DVX Utility 250 Service Manual, Page 39Get this manual

2006 Arctic Cat DVX Utility 250 Service Manual, Page 39

7Using needle nose pliers, remove one piston pin circlipTake care not to drop it into the crankcase KM718A 6Remove the cam
result AT THIS POINT To inspect cam chain guide, see Servicing Top-Side Components sub-section NOTE: If the existing rings
will not be replaced with new rings, note the location of each ring for proper installationWhen replacing with new rings,
replace as complete set onlyIf the piston rings must be removed, remove them in this sequence AStarting with the top ring,
slide one end of the ring out of the ring-grooveBRemove each ring by working it toward the dome of the piston while rotating
it out of the groove CCylinder DPiston NOTE: Steps 1-6 in the preceding sub-section must precede this procedure AT THIS POINT
AT THIS POINT To service cylinder, see Servicing Top-Side Components sub-sectionTo service piston, see Servicing Top-Side
Components sub-section ! CAUTION When removing the cylinder, be sure to support the piston to prevent damage to the crankcase