2006 Arctic Cat DVX Utility 250 Service Manual, Page 45Get this manual

2006 Arctic Cat DVX Utility 250 Service Manual, Page 45

12To disassemble the driveshaft, use the following procedureARemove the thrust washer; then remove the reverse gear 13To
BRemove the nut securing the driven bevel gear; then remove the gearAccount for washer CRemove the low driven gear snap ring
and washer; then remove the low driven gear and thrust washer CRemove the shaft and housing from the universal joint and
remove the shaft from the housingNOTE: If left-side components are still attached, remove the centrifugal clutchdriven pulley