2006 Arctic Cat DVX Utility 250 Service Manual, Page 46Get this manual

2006 Arctic Cat DVX Utility 250 Service Manual, Page 46

BWater Pump CStator Coil DTrigger Coil ERotorFlywheel AT THIS POINT To removeservice the water pump, see section 4 9Remove
service the stator coil, see Section 5 AT THIS POINT To service the trigger coil, see Section 5 12Remove the oil-through
and spring from the end of the crankshaft; then hold the rotorflywheel with an appropriate holding tool and remove the flywheel
nut and washer FOil Pump NOTE: Steps 9-13 in the preceding sub-section must precede this procedure 14Remove the rotorflywheel
(see RotorFlywheel in this sub-section)15Remove the starter drive gear and place together with the rotorflywheel to keep
the one-way clutch bearing intact 13Install the flywheel puller and crankshaft protector; then remove the rotorflywheelAccount