2006 Arctic Cat DVX Utility 250 Service Manual, Page 69Get this manual

2006 Arctic Cat DVX Utility 250 Service Manual, Page 69

BRotorFlywheel CTrigger Coil DStator Coil 4Install the starter idler shaft and gear in the crankcase; then install the starter
with the starter one-way bearing correctly installed, place the rotorflywheel onto the crankshaft and position the aligning
keyway with the key6Secure the rotorflywheel on the crankshaft with the nut and tighten to specifications; then install the
spring and oil-through in the crankshaft 1Install the oil pump with the arrow on the pump body directed upward; then secure
with the two cap screws and tighten securelyMake sure the shaft turns freely after installing 7Install the trigger coil and
stator coil in the right-side crankcase cover; then secure with the existing hardware and tighten securelyEWater Pump FTransmission
2Install the oil pump driven sprocket and drive chain; then secure the driven sprocket with circlip3Install the oil pump