2006 Arctic Cat DVX Utility 250 Service Manual, Page 80Get this manual

2006 Arctic Cat DVX Utility 250 Service Manual, Page 80

NOTE: Note the locations of the jets, pilot screw, and needle jet holder for disassembling procedures ASSEMBLING 1Thread
the needle jet holder assembly into the carburetor and tighten securely 4Secure the needle jet holder with wrench; then remove
the main jet5Remove the needle jet holder; then remove the slow jet and the starter jet6Remove the pilot screwAccount for
spring, washer, and O-ring7Unscrew and remove the idle screwAccount for the spring 5Place the float assembly (with float
needle valve) into position and secure to the carburetor with the float pin; then install the baffle plateKM440A 8Remove
the two screws securing the housing cover; then remove the coverAccount for an O-ring, diaphragm, and spring4-4 NOTE: Check