2006 Arctic Cat DVX Utility 250 Service Manual, Page 85Get this manual

2006 Arctic Cat DVX Utility 250 Service Manual, Page 85

4On the Utility model, install the front cover and fender assembly; then install the front rack (see Section 8)5Fill the
does not open, it must be replaced3Inspect all coolant hoses, connections, and clamps for deterioration, cracks, and wear
NOTE: All coolant hoses and clamps should be replaced every four years or 4000 miles INSTALLING 1Place the thermostat and
O-ring into the thermostat housing; then secure the thermostat housing cover to the thermostat housing with the two cap screwsTighten
securely2Fill the cooling system with the recommended amount of antifreezeCheck for leakageKM136A 8On the Utility model,
install the cover and rack (see Section 8) REMOVING HosesThermostat REMOVING 1Remove the radiator (see Radiator in this section)2Remove
the fan assembly from the radiatorINSTALLING 1Drain approximately one U.Sqt of coolant from the cooling system2Remove the
two machine screws securing the thermostat housing cover to the thermostat housingAccount for an O-ring and thermostat 1Position