2006 Arctic Cat DVX Utility 250 Service Manual, Page 86Get this manual

2006 Arctic Cat DVX Utility 250 Service Manual, Page 86

Water Pump REMOVINGDISASSEMBLING 2Inspect the mechanical seal and pump drive seal for damageNOTE: If the mechanical seal
NOTE: Whenever part is worn excessively, cracked, or damaged in any way, replacement is necessary 1Press the seal washer
into the impeller by hand2Install the water pump drive seal; then drive the mechanical seal into the crankcase cover using
an appropriate seal driver3Install the impeller with seal washer onto the water pump shaft and tighten securely4Place the
water pump case into position and secure with the four cap screws5Fill the cooling system with the recommended amount of
antifreezeNOTE: While the cooling system is being filled, air pockets may develop; therefore, run the engine for five minutes
after the initial fill, shut the engine off, and then fill the cooling system 1Clean all pump components in parts-cleaning