2006 Arctic Cat DVX Utility 250 Service Manual, Page 102Get this manual

2006 Arctic Cat DVX Utility 250 Service Manual, Page 102

NOTE: If the axle bearings are replaced, replace the dust seals with new onesAlways pack the bearings with good quality wheel
Bearings ATV2185 2Measure the rear axle runout as shown using blocks and dial indicatorIf the axle runout exceeds 1.5 mm
(0.06 in, the axle must be replaced 1Pack the new bearings with good quality wheel bearing grease; then install the right
bearing first using an appropriate bearing installerThe sealed side of the bearing must be directed inward2Install the spacer;
then install the left bearing 3Inspect the dust seals for wear or damageIf any defect is found, replace the dust seal4Inspect
the axle bearings by rotating them by handIf any roughness, binding, or excessive looseness is found, replace the axle bearings